Using a Scan Tool

Using a scan tool go to the ABS live data screen and all the sensors, data and what it is telling you.

#CONT DTCS IN MOD----------------------------------- 3

ABS VALV CTRL RELAY --------------------------------ON

ABS WARN LAMP STATUS -----------------------------OFF

BAT POSITIVE VOLT -----------------------------------14.63 V

BRAKE SW IN -------------------------------------------OFF

BREAK WARN LAMP STATE ---------------------------ON

HYDRAUL PUMP MOTOR -----------------------------OFF

HYDRAUL PUMP MOTOR -----------------------------OFF

LF ABS IN VALV ---------------------------------------OFF

LF ABS OUT VALV -------------------------------------OFF

LF WHEEL SPD SENSOR------------------------------- 0 KPH

LR ABS IN VALV ---------------------------------------OFF

LR ABS OUT VALV -------------------------------------OFF

LR WHEEL SPD SENS ----------------------------------0 KPH

RF ABS IN VALV ---------------------------------------OFF

RF ABS OUT VALV -------------------------------------OFF

RF WHEEL SPD SENS ----------------------------------0 KPH

RR ABS OUT VALV -------------------------------------OFF

RR WHEEL SPD SENS ----------------------------------0 KPH

The ABS control relay is correctly operated and provides relevant information and gives a good condition. I did this experiment with the engine running and the gear was placed at the neutral position.

Using the scan tool on the vehicle you have assigned to. Go to the actuator test screen. Note below what component you have tested and what happened when you tested that component and the test results.

These are the actuator conditons which is collected through the scan tool and the results shows that they are in good condition.